B&D Easylifter Manuel d'instructions télécharger pdf (Page 9)

MOUNTING THE OPENER

FIG. 11

FIG. 12

CHECK IF “U”

BOLT IS TIGHT

REMOVE “U” BOLT

REMOVE BRACKET

ROPE

SUPPORT PROP

TIGHTEN “U” BOLT

REFIT WALL BRACKET

UNTIE ROPE

REMOVE PROP

TIGHTEN LOCKING BOLTS

4. FIXING DRIVE UNIT TO THE DOOR

The Easylifter Drive Assembly can be fixed to the rolling

garage door in a variety of ways. Described below is one

method of fixing. Make sure there is enough side room (135mm

from the end of the door shaft to the wall) to slide the drive unit

onto the shaft.

PLEASE NOTE: THE INSTRUCTIONS FOR FIXING THE DRIVE

ASSEMBLYTO THE DOOR IS FOR RIGHT HAND INSTALLATION.

FITTING DRIVE UNIT TO DOOR

(Fig. 10, Fig. 11 and Fig. 12).

1. Check that the door shaft U bolt is securely tightened on the

left hand side of the door.

2. Raise the door and tie a rope around the centre to secure

the roll.

3. Support the right hand end of the door with a suitable prop,

e.g. step ladder and soft padding to protect the door surface.

WARNING: DO NOT ALLOW CHILDREN/PERSONS

AROUND THE DOOR AND PROP. SERIOUS PERSONAL

INJURY AND/OR PROPERTY DAMAGE CAN RESULT

FROM FAILURE TO FOLLOW THIS WARNING.

4. Check that Steps 2 and 3 was completed. Carefully loosen

and remove the right hand door shaft U bolt.

5. Make sure that the door supporting prop is secure. While the

door is supported remove the right hand door mounting

bracket from wall.

6. Remove the drive unit from the packaging. Try to rotate the

drive gear by pushing on the fork. If the gear does not rotate

manual mode has to be selected. To select pull down on the

string handle, then release slowly. The drive gear should now

rotate freely.

7. Slide the drive unit over the door axle making sure that the

fork extends into and over one of the spokes of the door drum

wheel.

8. Refit the door mounting bracket to the wall. In some cases

the bracket may have to be re-positioned. Re-tighten the door

shaft U bolt. Remove door supporting prop and untie the rope

from the curtain.

9. Straighten the drive unit and position as per Fig. 12. Tighten

the two locking bolts firmly to secure the drive unit.

10. Check the manual operation of the door by raising and

lowering the door. The door should run smoothly and not catch

on any part of the drive unit.

11. Adjust the length of the manual release cord so that it can

be easily reached by an adult of average height (ie. less than

1.8m tall).

FIG. 10

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

B&D Easylifter Manuel d'instructions Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage B&D Easylifter