B&D Controll-A-Door ShedMaster Spécifications télécharger pdf (Page 13)

CODING TRANSMITTERS

9. SETTING TRANSMITTER CODES

Make sure to insert the battery into the transmitter. The

memory in the openers receiver can store up to six unique

remote control transmitters, one dipswitch transmitter and one

entry keypad.

9.1 CODE SETTING THE RECEIVER WITH SMART

CODE OR DIP SWITCH TRANSMITTERS

1. Make sure that the battery is inserted in the Transmitter

2. Press the Door Code button on the opener. The Code Set LED

will illuminate to indicate the opener is in Code Learn mode.

This mode is exited If a valid code is not stored in 15 seconds.

SMART CODE TRANSMITTER - Press and hold the

remote control transmitter button to be programmed until the

Code Set LED flashes. This indicates successful programming

of the transmitter. (Fig. 13)

DIP SWITCH TRANSMITTER - Select your dipswitch

combination of switches by sliding them on or off. Now

press and hold the remote control transmitter button to be

programmed until the Code Set LED flashes, indicating

successful programming. (Fig.14)

4. Release the button in the remote control transmitter - the code

is now set.

10.1 - SETTING ENTRY KEYPAD TRANSMITTER

CODE.

1. Make sure that the battery is set in the Keypad

Transmitter.

2. Press the Code Set button on the opener, the Code Set LED

will illuminate to indicate the opener is in Code Learn

mode. (if a valid code is not stored within 15 seconds, the

opener will exit Code Learn).

3. For an entry keypad the desired code should be typed (a

minimum of four numbers or letters) and the ENTER

button held down until the Code Set LED flashes to

indicate that it has been learnt.

4. Release the button on the keypad transmitter.

The code is now set.

FIG. 13

Press and hold

Door Code

Button

10.2 DELETING PROGRAMMED CODES

1. If the Door Code button on the opener is pressed and held for

6 seconds, the LED will blink rapidly for one second to indicate

that all programmed codes have been erased.

11. LOCKING THE CONTROL PANEL

To lock or disable the control panel a transmitter button must be

coded for the operate function.

1. Press and hold a coded button on a transmitter and the Plus (+)

button for 4 seconds until you hear a beep.

2. Release both buttons.

3. To test press the Operate button to confirm that the door

does not move.

To unlock the control panel repeat the above procedure.

FIG. 14

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

B&D Controll-A-Door ShedMaster Spécifications Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage B&D Controll-A-Door ShedMaster